ATMEL ICE DRIVER HOW TO

On most ribbon cables, the red wire is pin 1 and connects to a pin on the corner of the connector. See the images below to verify the connection. Make sure that the key that protrudes from the 6 pin connector at the end of the ribbon cable points towards the USB connector side of the Arduino Uno. Just make sure to plug it into the AVR port and NOT the SAM port or connector.Ĭonnect the Ribbon Cable to the Arduino Uno ICSP HeaderĬonnect the 6 pin (3 × 2) header found at the other end of the ribbon cable to the ICSP header of the Arduino Uno. The 20 pin (5 × 2) fine pitch connector at the end of the cable plugs into the Atmel-ICE AVR connector.īecause of the key on the connector, the ribbon cable can't be plugged in the wrong way around. Connect the Ribbon Cable to the Atmel-ICE AVR PortĬonnect the Atmel-ICE ribbon cable into the Atmel ICE via the connector marked AVR on the body of the Atmel-ICE. It fine to use the basic kit with the book as the extra connectors are not needed. The Atmel-ICE Basic Kit (ATATMEL-ICE-BASIC) comes with a USB cable and one ribbon cable and is cheaper than the full kit. The Atmel-ICE Full Kit (ATATMEL-ICE) is more expensive than the basic version and has additional connectors in the box. The Atmel-ICE has both programming and debugging capabilities. It applies to the Atmel-ICE USB programmer debugger, with part number atatmel-ice and the cheaper Atmel ICE basic, part number ATATMEL-ICE-BASIC.Įither the atatmel-ice or atatmel-ice-basic can be used with the book instead of the AVR Dragon or AVRISP mkII.

ATMEL ICE DRIVER HOW TO

This article explains how to connect an Atmel-ICE to an Arduino Uno via the ICSP header as used in the book C Programming with Arduino. 11 November 2019 How to Connect an Atmel-ICE to an Arduino Uno via the ICSP Header

Atmel ice driver